Wireless Remote Control System Receiver

1, 220V 1CH wireless remote control system receiver FYZ1424, suitable for anti-theft alarm, remote control electric door and window, signal control, industrial control, lifting equipment electronic control circuit.
Remote control switch module, independent output relay contact, is very suitable for direct control of all types of load; products use wireless fixed code technology, no interference switch.
The components of the remote switch assembly can be checked after purchase.
2, Each road can support a maximum of 10 current, AC load, you can directly drive each relay through a set of normally open, normally closed contacts. In order to extend the life of the receiving board, we do not recommend charging high power control. It is recommended that each control power supply be 1000 W (impedance load); 600 W (inductive load); 400 W (under motor load).
3. Specifications:
Working voltage: 220 V
Operating frequency: 315MHz / 433MHz. If there is no information, it will send 315MHz
Maximum load: 1500W,
Working mode: jog, self-locking or interlocking (can be adjusted by welded joint)
4. Learning and elimination methods: There is a learning button on the control panel of the touch switch, which is used for learning and remove code.
Press and hold the Learn button fortthree seconds.
When the indicator is flashing.
Press any button on the remote control to signal, the indicator flashes twice and then goes out. This means that you have successfully learned it.
Different remote wireless codes can be used, and the controller learns more than 12 2262 or 1527 chips.
How to delete the remote control: Keep the learning button for about 8 seconds, the indicator light goes out, and the code you have learned before will be deleted.
5, Delivery includes: 1 x receiver (without battery, no battery required), 4 x transmitter (both built a CR2016 battery)